1c
Checking components
The following installation tools are required:
Phillips screwdriver (M3 to M6)
Flat-head screwdriver (M3 to M6)
Diagonal pliers
Floating nut mounting bar
1 Installation Preparations
Only materials used in the installation process are listed here. The Packing List contains all materials
required by the installation. The bag containing the Packing List is attached to the outside of the carton.
3
Disk enclosure (2 U)
Controller enclosure (3 U)
Installation template
(for 2 U devices)
Front panel of a
2 U device
Multi-mode optical fiber
cable
High-density disk enclosure (4 U)
Adjustable guide rails Ball bearing guide rails
Network cable
Disk enclosure (4 U)
Installation template
(for 3 U devices)
Front panel of a 3 U
device
Installation template (for
4 U devices)
Front panel of a 4 U
device
Checking installation tools Checking circuit breakers
1b 1a
NOTICE
Cable tray
Floating nut and M6 screw
Ground cable
Mini SAS HD optical
cable
Mini SAS HD electrical
cable
Serial cable
A storage system power failure may cause devices connected
to the same circuit breaker to power off unexpectedly.
Therefore, ensure that the storage system power supplies
have functioning circuit breakers with the following amps:
AC power: not smaller than 10 A
DC power: not smaller than 50 A for controller enclosures,
not smaller than 18.5 A for disk enclosures
To Next Page
Loading...
