Huawei OptiX OSN 8800 T16 - Page 121

118
MON SYS LINE
RS232-1 RS232-2
LAN
CRPC/ROP
1
ETH1
ETH2
SW4A
SW4B
2
AUX
STAT
PRO
G
ETH1 ETH2
Subracks are connected in ring-
like structure, connect the
CRPC/ROP board to the ETH3
port using a cable.
ETH3COM
Subrack 1
Subrack 2
T64
6800
Communication
cable between the
CRPC/ROP board
and subrack
Tributary power
output terminals
Power cable of
CRPC/ROP frame
Route the main and backup power cables of the CRPC/ROP frame to the power interfaces of the
frame. Route the other end of the power cables along the cable routing area on the right side of
the cabinet to the power cable terminal block on the top of the cabinet.
Plug one end of the crossover network cable into the LAN port on the CRPC/ROP board. Plug
the other end to the ETH1 or ETH2 port on the EFI2 board in the corresponding OptiX OSN
8800 T64 subrack (or the ETH1 or ETH2 port on the AUX board in the corresponding OptiX
OSN 6800 subrack).
Installing and Routing Cables to the CRPC/ROP
T64 + 6800 Subrack
NOTE