120
Plug one end of the crossover network cable into the LAN port on the CRPC/ROP board. Plug
the other end to the ETH1 or ETH2 port on the EFI board in the corresponding OptiX OSN
8800 T16 subrack1.
T16 Subrack
Route the main and backup power cables of the CRPC/ROP frame to the power interfaces of
the frame. Route the other end of the power cables along the cable routing area on the right
side of the cabinet to the power cable terminal block on the top of the cabinet.
Installing and Routing Cables to the CRPC/ROP
Communication
cable between the
CRPC/ROP board
and subrack
Tributary power
output terminals
Power cable of
CRPC/ROP frame
Subracks are connected in ring-
like structure, connect the
CRPC/ROP board to the ETH3
port using a cable.
NOTE
T16
subrack 1
T16
subrack 2
T16
subrack 3
To Next Page
Loading...
