Huawei OptiX OSN 8800 T16 - Page 124

MON SYS LINE
RS232-1 RS232-2
LAN
MON SYS LINE
RS232-1 RS232-2
LAN
Subrack1
121
Universal Platform Subrack
MON SYS LINE
RS232-1 RS232-2
LAN
MON SYS LINE
RS232-1 RS232-2
LAN
SW1A
SW1B
Subrack 3
Subrack 2
CRPC 2
CRPC 1
Installing and Routing Cables to the CRPC/ROP
Route the main and backup power cables of the CRPC/ROP frame to the power interfaces of the frame. Route the
other end of the power cables along the cable routing area on the right side of the cabinet to the power cable terminal
block on the top of the cabinet.
Plug one end of the crossover network cable into the LAN port on the CRPC/ROP board. Plug the other end to
the ETH1 or ETH3 port on the EFI board in the corresponding subrack.
Main power
cables for
the
CRPC/ROP
frame
Backup
power
cables for
the
CRPC/ROP
frame
CRPC/ROP Power cables