33
In an ETSI Cabinet
b
Remove the mounting ears pre-assembled on the
chassis.
Fix the shorter sides of the removed mounting
ears in the middle positions on the chassis.
Install the chassis to the cabinet. Install the PGND cable.
Position for a mounting ear if
the Y-Cable is installed in an
ETSI cabinet with middle
columns
Position for a mounting ear if
the Y-Cable is installed in
an ETSI cabinet with front
columns
The following steps assume
that the Y-Cable is installed in
an ETSI cabinet with middle
columns. For an ETSI cabinet
with front columns, select the
position for mounting ears
with reference to the figure on
the left.
0.56 ± 0.05 N.M
M3
2# screwdriver
0.56 ± 0.05 N.M
M3
2# screwdriver
2.04±0.20N.M
M6
2# screwdriver
1.43±0.14N.M
M4
2# screwdriver
To Next Page
Loading...
