Huawei Quidway S5000 Series

Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches Chapter 4 User Interface Configuration
4-5
such user logs out, he cannot log in again. In this case, a user can log in to the switch
through the user interface only when the terminal service is enabled again.
Table 4-8 Enable/disable terminal service
Operation Command
Enable terminal service shell
Disable terminal service undo shell
By default, terminal service is enabled on all the user interfaces.
Note the following points:
z For the sake of security, the undo shell command can only be used on the user
interfaces other than AUX user interface.
z You cannot use this command on the user interface via which you log in.
z You will be asked to confirm before using undo shell on any legal user interface.
II. Configure idle-timeout
Table 4-9 Configure idle-timeout
Operation Command
Configure idle-timeout idle-timeout minutes [ seconds ]
Restore the default idle-timeout undo idle-timeout
By default, idle-timeout is enabled and set to 10 minutes on all the user interfaces. That
is, the user interface will be disconnected automatically after 10 minutes without any
operation.
idle-timeout 0 means disabling idle-timeout.
III. Lock user interface
This configuration is to lock the current user interface and prompt the user to enter the
password. This makes it impossible for others to operate in the interface after the user
leaves.
Table 4-10 Lock user interface
Operation Command
Lock user interface lock