Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches Chapter 4 User Interface Configuration
4-8
Note:
By default, the password is required for authenticating the Modem and Telnet users when they log in. If the
password has not been set, when a user logs in, he will see the prompt “password required, but none set.”.
If the authentication-mode none command is used, the Modem and Telnet users will not be required to
input password.
II. Set command level used after a user logging in
The following command is used for setting the command level used after a user logging
in.
Perform the following configuration in local-user view.
Table 4-15 Set command level used after a user logging in
Operation Command
Set command level used after a user logging in
service-type { ssh [ level level | telnet [ level level ] ] |
telnet [ level level | ssh [ level level ] ] }
Restore the default command level used after a
user logging in
undo service-type { ssh [ level | telnet [ level ] ] | telnet
[ level | ssh [ level ] ] }
By default, the specified logon user can access the commands at Level 1.
III. Set command level used after a user logs in from a user interface
You can use the following command to set the command level after a user logs in from
a specific user interface, so that a user is able to execute the commands at such
command level.
Perform the following configuration in user interface view.
Table 4-16 Set command level used after a user logging in from a user interface
Operation Command
Set command level used after a user logging in from a user interface
user privilege level level
Restore the default command level used after a user logging in from a user
interface
undo user privilege level
By default, a user can access the commands at Level 3 after logging in through the
AUX user interface, and the commands at Level 0 after logging in through the VTY user
interface.
To Next Page
Loading...
Need help?
General