Huawei SUN2000-110KTL-M0 - Determining the Installation Position

Category Tool
Measuring tape Bubble or digital
level
Hydraulic pliers Heat shrink
tubing
Heat gun Cable tie Scissors
N/A
Personal
protective
equipment (PPE)
Safety gloves Safety goggles Anti-dust
respirator
Safety boots
4.3 Determining the Installation Position
Installation Environment Requirements
● Do not install the inverter in working or living areas.
● If the device is installed in public places (such as parking lots, stations, and
factories) other than working and living areas, install a protective net outside
the device, set up a safety warning sign to isolate the device, and prevent
unauthorized personnel from approaching the inverter. This is to avoid
personal injury or property loss caused by accidental contact or other reasons
during device operation.
● Do not install the inverter in areas with
ammable materials.
● Do not install the inverter in areas with explosive materials.
● Do not install the inveter in areas with corrosive materials.
● Do not install the inverter where its enclosure and heat sinks are easily
accessible, because the voltage is high and these parts are hot during
operation.
● Install the inverter in a well-ventilated environment for heat dissipation
● If the inverter is installed in an airtight environment, a heat dissipation device
or ventilation device must be installed to ensure that the indoor ambient
SUN2000-(100KTL, 110KTL, 125KTL) Series
User Manual 4 Installation
Issue 07 (2020-09-15) Copyright © Huawei Technologies Co., Ltd. 26