5
Installing the AC Output Power Cable to SUN2000-(8KTL–20KTL)-M2
1.4
•
Ensure that the protective layer of the AC output power cable is inside the connector, that
the core wires are totally inserted into the cable hole, and that the cable is connected
securely. Failing to do so may cause the device malfunction or damage.
•
The hex key is delivered with the SUN2000 and bound to the hanging kit at the bottom of
the SUN2000.
It is recommended that silica gel or paint be applied around the ground terminal after the PE
cable is connected.
Installing the PE Cable for SUN2000-(8KTL–20KTL)-M2
1.3
1. Connect the AC output power cable to the AC connector.
Before connecting cables, ensure that the DC switch on the SUN2000 and all the switches
connected to the SUN2000 are set to OFF. Otherwise, the high voltage of the SUN2000 may
result in electric shocks.
Hanging kit
Hex key
Hex Key
Stripping
Requirements
To Next Page
Loading...
Need help?
General