SUN2000-(2KTL-5KTL)-L0
User Manual
Copyright © Huawei Technologies Co., Ltd.
Installation Environment Requirements
The SUN2000 must be installed in a well-ventilated environment to ensure good heat
dissipation.
When installed under direct sunlight, the power of the SUN2000 may be derated due to
additional temperature rise.
Install the SUN2000 in a sheltered place or install an awning over the SUN2000.
Mounting Structure Requirements
The mounting structure where the SUN2000 is installed must be fireproof.
Do not install the SUN2000 on flammable building materials.
Ensure that the installation surface is solid enough to bear the weight load.
In residential areas, do not install the SUN2000 on drywalls or walls made of similar
materials which have a weak sound insulation performance because the noise generated
by the SUN2000 is noticeable.
Installation Angle Requirements
The SUN2000 can be wall-mounted or pole-mounted. The installation angle requirements are
as follows:
Install the SUN2000 vertically or at a maximum back tilted angle of 15 degrees to
facilitate heat dissipation.
Do not install the SUN2000 at forward tilted, excessively back tilted, side tilted,
horizontal, or upside down positions.
Figure 4-1 Installation angle
To Next Page
Loading...
