SUN2000-(2KTL-5KTL)-L0
User Manual
Copyright © Huawei Technologies Co., Ltd.
Ensure that the cable jacket is inside the connector.
Ensure that the exposed core wire is totally inserted into the cable hole.
Ensure that the signal cables are connected securely.
Ensure that no cable is twisted.
If two signal cables are required, ensure that they have the same outer diameter.
Figure 5-18 Assembling a signal connector
This document takes the connection of two signal lines as an example. If only one signal cable
needs to be connected, block the unused cable hole on the seal using a cap and tighten the
cable gland.
To Next Page
Loading...
