SUN2000-(2KTL-5KTL)-L0
User Manual
Copyright © Huawei Technologies Co., Ltd.
8 Handling the SUN2000
8.1 Removing the SUN2000
Procedure
Step 1 Power off the system by following the instructions in 6.5 Powering Off the System.
Step 2 Disconnect all cables from the SUN2000, including signal cables, DC input power cables, AC
output power cables, and PE cables.
Step 3 Remove the WiFi antenna or 4G Smart Dongle from the SUN2000.
Step 4 Remove the SUN2000 from the mounting bracket.
Step 5 Remove the mounting bracket.
----End
8.2 Packing the SUN2000
If the original packaging is available, put the SUN2000 inside it and then seal it using
adhesive tape.
If the original packaging is not available, put the SUN2000 inside a suitable cardboard
box and seal it properly.
8.3 Disposing of the SUN2000
If the SUN2000 service life expires, dispose of it according to the local disposal rules for
electrical equipment and electronic component waste.
To Next Page
Loading...
