15
Set Language
Start
Set Output mode.
Set Positive
batteries.
Set Negative
batteries.
Set Battery
capacity.
End
On the default screen, hold down for more than 5 seconds. Release the
button when you hear a beep sound. The inverters are started.
Set Frequency
level.
Set Voltage level.
The following uses three-phase input and three-phase output of the UPS in normal mode as
an example.
The parameter setting screens are shown as follows.
Set Language (default: English), System Parameters, and Battery Parameters.
Incorrectly setting battery parameters compromises battery
safety and battery backup time.
For details about parameter settings, see the
UPS2000-G-(6
kVA–20 kVA) User Manual
.
Scenario 1: Initial Startup
To Next Page
Loading...
