How to reset the password on a Huawei UPS?
If you forgot only the LCD password (the preset password is 000001), use the feature code (the preset feature code is 999999) to activate the LCD password. If you forgot both the LCD password and feature code, contact local technical support.
What to do if Huawei UPS2000-G-6KRTS has no output voltage?
If the UPS has no output voltage but does not report a fault, check the output power cable connection to ensure it is properly connected.
What to do if Huawei UPS2000-G-6KRTS does not start?
If the UPS does not start after pressing the power button, ensure that you press it for more than 5 seconds until you hear a beep sound.
How to fix a Huawei UPS2000-G-6KRTS when the LCD displays nothing?
If the LCD displays nothing and the system doesn't perform self-tests, first check the UPS input power cable connection to ensure the input power supply is properly connected. Also, use a voltmeter to check whether the UPS input voltage meets the required specifications, as it may be less than the lower threshold or greater than the upper threshold.
Why is the mains indicator off on my Huawei UPS?
The mains indicator might be off because the mains voltage or frequency exceeds the UPS input range. Use a multimeter to verify that the input voltage and frequency meet the specified requirements.
What to do if the battery indicator blinks on my Huawei UPS2000-G-6KRTS?
If the battery indicator is blinking and the buzzer is buzzing, it indicates that the UPS is about to shut down due to insufficient battery reserve. To prevent data loss or damage, immediately save load data and shut down primary loads. Also, verify that the number of batteries and battery capacity are correctly set based on the actual configuration.
What to do if the AC input indicator is off on my Huawei UPS2000-G-6KRTS?
If the AC input indicator is off and the UPS is running on battery despite normal mains, it could be due to the UPS mains switch being OFF. Ensure the UPS mains switch is turned ON. Alternatively, the input cable may not be properly connected; check the UPS input power cable connection.
To Next Page
General