Huawei USG6310 - Default Configuration; Connecting to the Internet

2
Secospace USG6000
0 2 4 6
1 3 5 7
RST
12V ; 3A
CONSOLE
XXXXXXXXXXXXXXXXXXXXXXXXXXX
Administrator
Intranet
Rear panel
Switch
GE0/0/4 GE0/0/6GE0/0/0
3
4
4
4
1
2 2
Default Configuration
The following table lists the default configuration.
Item Description
GE0/0/0 The IP address is 192.168.0.1.
Administrator account/password You can use the default account/password (admin/Admin@123) to log in through web or
console.
Connecting to the Internet
Collect the information in the following table based on the WAN mode you use and the IP address plan for the LAN. The un-
derlined red texts in the table are examples for reference only.
Item Port Description
WAN GE0/0/4 WAN Mode Static IP IP Address: 1.1.1.1 Request your ISP or
network administrator
to provide the data.
Subnet Mask: 255.255.255.0
Default Gateway: 1.1.1.254
Primary DNS: 2.2.2.2
(Optional) Secondary DNS: 2.2.3.3
PPPoE User name/Password: user/Password123
DHCP
-
The device functions
as a DHCP client.
LAN GE0/0/6 IP Address: 10.0.0.1
Subnet Mask: 255.255.255.0
The LAN IP address range
shall be pre-determined.
DHCP server IP address range: 10.0.0.1 to 10.0.0.254
1. Set the IP address to 192.168.0.2 (or any other in the range of 192.168.0.2 to 192.168.0.254) and subnet mask to
255.255.255.0 of the corresponding network interface on the administration PC.
2. Open a web browser and navigate to https://192.168.0.1:8443.
3. Enter the user name (admin) and password (Admin@123) in the login dialog box, and then click Login. You need to
change the user password as instructed after the first login.
4. In the Startup Wizard page that is displayed, click Next to access the Basic Configuration page. Change the device
name and click Next.
IftheStartup Wizardpageisnotdisplayed,clicktheSystemtabandchooseWizard>Startup Wizardinthe
navigationtree.