Hubsan H501S Advanced User Manual

Hubsan H501S Advanced – Cheat Sheet
Settings Menu
Hold Enter button and pull throttle stick down
RSSI Mode
Hold down exit button and switch on transmitter
Circle fly
Hold down “Down” button for a long time. When you see ‘circle fly’ on the screen, let go of the
video button
Bind transmitter with quad
Hold down Enter button and power on transmitter
Manual Compass Calibration
Push the left stick to the most left side, and move the right stick left to right quickly until the
transmitter displays “Calibrate Compass 1”
Horizontal Calibration (IMU roll / pitch)
Push the left stick to the most right side, and move the right stick left to right quickly until the 4 LED
indicators blink yellow slowly. Calibration succeeded when the 4 LED indicators stop blinking slowly.
Rotational Calibration (use paper under the quad feet to allow smooth rotation)
Push the left stick to the top side, and move the right stick up and down quickly until the 4 LED
indicators blink in yellow slowly.
When the 4 LED indicator turns into red and blink circularly, rotate the quad horizontally clock-wise
until the 4 LEF indicators remain lighted in green.
When the 4 LED indicators turns into red again, rotate the quad horizontally clock-wise until the 4
LED indicators explosion-flashing simultaneously.
Recalibrating the Accelerometer
Quad on level surface, left stick to lower right, toggle right stick left and right until lights flash.
Transmitter Stick Calibration
Mode 2: Push both sticks to the upper left corner and power on the transmitter simultaneously, the
LCD will display “Calibrate Stick Mode 2”, rotate both sticks in circles for three times, release both
sticks, then press any trim for 1.5 seconds until one “beep” heard which indicates a successful
calibration.

Hubsan H501S Advanced Specifications

General

Camera	1080p HD
Flight Time	20 minutes
Control Range	300 meters
Battery	7.4V 2700mAh LiPo
GPS	Yes
Follow Me Mode	Yes
Return to Home	Yes
Diagonal Size	310mm
Weight	410 g
Charging Time	150 minutes
Max Speed	60km/h
Transmitter Frequency	2.4GHz
Headless Mode	Yes
FPV	5.8GHz Video Transmission
Transmitter Battery	4 x AA

Summary

Hubsan H501S Advanced Operations

Settings Menu

Access the settings menu by holding the Enter button and pulling the throttle stick down.

RSSI Mode Activation

Enter RSSI Mode by holding the exit button and switching on the transmitter.

Initiate Circle Fly

Start Circle Fly by holding the 'Down' button, then releasing the video button when 'circle fly' appears.

Bind Transmitter to Quad

Bind the transmitter to the quad by holding the Enter button and powering on the transmitter.

Drone Calibration Procedures

Manual Compass Calibration

Calibrate compass by moving sticks until transmitter displays 'Calibrate Compass 1'.

Horizontal Calibration (IMU)

Calibrate IMU roll/pitch by moving sticks until LEDs blink yellow slowly and then stop.

Rotational Calibration Steps

Calibrate rotation by moving sticks and rotating quad until LEDs indicate success.

Accelerometer Recalibration

Recalibrate accelerometer on a level surface by toggling sticks until lights flash.

Transmitter Stick Calibration

Calibrate transmitter sticks by pushing them to corners, rotating, and pressing trim.

Finding a Lost Quadcopter

Using GPS Coordinates

Locate a lost quad using Google Maps with the GPS coordinates from the transmitter screen.