16
ASSEMBLY (continued)
14.CAUTION: Do not use TEFLON tape on pipe threads - -
see MAINTENANCE: General Precautions.
If hydraulic hoses have been removed, thread hydraulic
hoses into handle. Slide shrouds over fittings.
15.Assemble electrical cord to connector. Screw strain
relief grommet into handle. Push cord through grommet.
Attach cord to trigger switch. Press switch into handle and
tighten set screw against switch. Pull excess cord down
through handle and strain relief grommet. Tighten grommet.
16.See CAUTION
in 14. - screw coupling nipple onto PULL
pressure hose (from “P” port of tool). Screw coupling body
onto RETURN pressure hose.
17.Before attaching nose assembly and using tool, read entire
PREPARATION FOR USE section. Hold 7/16” hex wrench
in back of tool when tightening edict. After collet bottoms,
loosen collet 1/4 turn or less until ball lock can be felt
dropping into groove in piston rod. Use pintail tube if pintail
will fall through.
18.See W
ARNING in DISASSEMBLY and reverse the given
procedure i. e. CONNECT HOSES FIRST, and then,
connect electrical control cord.
To Next Page
Loading...