Huddly L1 - Streaming; Factory Reset; Recycling

5
Streaming
e L1 support streaming over the Real Time
Streaming Protocol (RTSP) and Open Network Video
Interface Forum (ONVIF).
Factory reset
To reset the L1 to factory default, use the following
procedure:
1. Disconnect the Ethernet cable from the camera
2. Use a thin object to press the reset buon
through the hole located in the top le corner of
the connector cavity
3. Keep the buon pressed while reinserting the
Ethernet cable
4. Aer power has been reapplied to the camera,
keep the reset buon pressed for 10 seconds
5. e camera will now reset to factory seings
Recycling
At the end of life for this product, local rules and regulations
shall be followed. is product is ment to be recycled, and if
applicable and/or possible, should be handed in to a collection
point for recycling purposes.