3
Safety and Caution
Information
Temperature
This device is intended for use in ambient temperatures between 0 °C and
35 °C (32 °F and 95 °F). Avoid using or storing next to heat sources, in
direct sunlight, or outside the intended temperature ranges.
Modify
Modication to thermal solution, device components or enclosure shall
violate regulatory compliance requirements and may induce safety hazards.
User Instructions
The S1 camera is made for easy installation, using only a single RJ45
Ethernet cable for both power and communications with a host computer.
Installation
Use the ¼” tripod mount found on the bottom face of the camera to attach
a bracket to the S1. Using the bracket, mount the S1 at a maximum height
of 2m.
The S1 must be installed in a location where the top and bottom venting
holes are unobstructed, to ensure proper airow.
Connect minimum a Cat5e rated Ethernet cable to the camera, and terminate
the cable in a Power over Ethernet (PoE) Power Sourcing Equipment (PSE)
enabled host or midspan adapter.
If third party Ethernet cables are to be used, then prioritise Ethernet cables
with short connectors. The long connector alternatives can be more difcult
to disconnect.
To Next Page
Loading...