4
Make sure to use the latest camera software by following the instructions
at: www.huddly.com/S1/setup
Power
The S1 cameras can be powered by a PoE PSE which adheres to the
following minimum requirements:
• Voltage range: 37–57V DC
• Maximum current: 0.35A
Streaming
The S1 support streaming over the Real Time Streaming Protocol (RTSP)
and Open Network Video Interface Forum (ONVIF).
Factory reset
To reset the S1 to factory default, use the following procedure:
1. Disconnect the Ethernet cable from the camera
2. Use a thin object to press the reset button through the hole
located in the top left corner of the connector cavity
3. Keep the button pressed while reinserting the Ethernet cable
4. After power has been reapplied to the camera, keep the reset
button pressed for 10 seconds
5. The camera will now reset to factory settings
Recycling
At the end of life for this product, local rules and regulations shall be
followed. This product is ment to be recycled, and if applicable and/or
possible, should be handed in to a collection point for recycling purposes.
To Next Page
Loading...