Front Wheel Bearings
Front wheel bearings (A), Figure 17,
should be cleaned and repacked with three
ounces of milled sodium soap base lubricant
every 5,000 miles. See page 60 for adjusting
procedure.
Rear Wheel Bearings
The rear wheel bearings (A), Figure 18,
should be cleaned and repacked with one
and one-half ounces of milled sodium soap
base lubricant every 5,000 miles. See page
63 for adjusting procedure.
20 H U D S O N T E R R A P L A N E
5. Refill sump with one measured pint of new S.A.E. 50 engine oil in summer
and 20 W in winter.
6. Check filter unit gasket, reinstall filter unit (E) and install wing nut (D).
7. Reinstall air cleaner on carburetor, tighten carburetor air horn clamp screw (B) (also
Electric Hand inlet pipe clamp screw (C) if necessary), and body brace bolt (A).
More frequent cleaning depends upon local dust conditions.
EVERY 5,000 MILES
To Next Page
Loading...
Need help?
General
