Clutch
Hudsonite Clutch Compound is permanently
sealed into the clutch to prevent loss. How-
ever, it should be drained every 5,000
miles and refilled with Hudsonite Clutch
Compound.
To insert Hudsonite, turn the engine until the
drain plug (A), Figure 19, in the front face
of the flywheel is visible through the timing
inspection hole in the left side of the engine
rear plate. Remove the plug and turn the
engine slowly until the star stamped in the
front face of the flywheel is visible
through the inspection hole. Allow a minute
in this position to drain, then turn the en-
gine until the filler hole again appears in
the timing hole and insert one-third pint of
Hudsonite. Replace plug and tighten securely. Hudsonite is available through all
Hudson dealers.
Shock Absorbers
Efficient operation of the direct-
acting, self-compensating shock ab-
sorbers with which your car is
equipped depends upon the quantity
and quality of fluid installed in them.
Have your Hudson dealer drain and
refill each unit with five ounces of
Genuine Hudson Shock Absorber Fluid
every 5,000 miles. See Figure 20.
.
O W N E R' S M A N U A L 21
Figure 20
To Next Page
Loading...
Need help?
General
