Huffy BMW - Assembly: Steering Wheel, Power Supply, and Seat; Steering Wheel Attachment; Power Supply & Seat Installation; Backrest Installation

9
Installing Steering Wheel, Power Supply and Seat
Assembly
Installation of steering wheel:
Installation of power supply, seat and backrest:
2
3
1
Driving
control
board
A
B
2
16
16
9
8
16
16
3
14
13
15
3
1
• Connect the steering wheel wire plug to the plug extend-
ing out of the car body hole.
• Put the connected plugs and wires down into the car
body hole.
NOTE: Ensure wires are not pinched our bound up.
• With J-shaped Steering Rod held (13) in place, put the
steering wheel (3) onto the Steering Rod end, and install
the steering wheel screw (14) and nut (15)
• When battery is installed or replaced, insert the
Red cable terminal into the Red battery positive
pole and the Black terminal into the Black battery
negative pole.
• Connect Plug (A) to Connector (B) rmly.
WARNING: Connecting incor-
rectly will cause a short circuit.
Insert the backrest (8) into place as shown and install
the backrest screws (16) securely.
After the power supply is installed, put the seat (9) into
place as shown, and install seat screws (16).