Need help?Do you have a question about the Hughes & Kettner Black Spirit 200 and is the answer not in the manual?
General| Power Output | 200 W |
|---|---|
| Amp Type | Solid State |
| Channels | 4 |
| EQ | 3-band EQ (Bass, Mid, Treble) |
| Effects Loop | Yes |
| Line Out | Yes |
| Headphone Out | Yes |
| MIDI | Yes |
| Bluetooth | Yes |
| Red Box | Yes, Red Box AE+ |
| Controls | Gain, Master, Presence, Resonance, Sagging |
| Effects | Reverb |
| Footswitch | Optional |
| Weight | 3.6 kg |
| Speaker Outputs | 1 x 8 Ohm, 1 x 16 Ohm |
Essential pre-operation checks and considerations for safe and optimal performance of the amplifier.
Explains how the amplifier's knobs function across different channels and modes, including programmable aspects.
Details how to switch between saved sound settings (presets) using MIDI or an app.
Guide to using the FSM-432 MIDI footswitch for preset selection and control.
Instructions on how to save custom sound settings into the amplifier's memory slots.
Information on using the dedicated iPad app for extended control and management of the amplifier.
Details the primary guitar input jack and its connection requirements.
Explains the Gain control's function in determining input sensitivity and preamp saturation.
Description of the Clean channel's sound characteristics and headroom.
Details the Crunch channel for classic overdrive tones.
Describes the Lead channel for enhanced musicality and solo performance.
Information on the Ultra channel for high-gain tones.
Explains the Boost function for enhancing specific frequencies.
Details the three-band EQ controls and their interaction.
Explains the Volume knob's role in adjusting preset levels and relative balance.
Describes the Noise Gate control and its IDBT™ technology.
How to access and engage the delay and modulation effects modules.
Details the digital reverb effect and its characteristics.
Information on the delay module, its controls, and Tap tempo function.
Describes the four modulation effects: Chorus, Flanger, Phaser, and Tremolo.
Explains the serial effects loop for integrating external processors.
Details the cabinet emulation selection for the Red Box AE+ output.
Controls the power amp volume and overall output level.
Adjusts the amp's resonance characteristics for tone shaping.
Controls the amount of harmonic overtones and high-frequency presence.
Allows control over power amp saturation and its effect on tone.
Connection for external speaker cabinets.
Output for headphones or line-level audio signals.
Emulated speaker output for direct connection to PA or recording devices.
Indicates the status of the Bluetooth connection (off, scanning, connected, failed).
Steps to activate Bluetooth and connect to a mobile device.
Instructions on how to turn off the Bluetooth connection.
Procedure for connecting the amp to a different Bluetooth device.
Configures MIDI channel and Omni mode for controller communication.
Accesses and modifies global settings like EQ and Cabinet type modes.
Lists MIDI controller numbers for various amp parameters.
To Next Page