Need help?Do you have a question about the Hughes & Kettner STOMPMAN and is the answer not in the manual?
General| Power | 50 W |
|---|---|
| Controls | Gain, Master, Sagging, Presence, Resonance, Tone, Boost |
| Effects | Reverb |
| Speaker Outputs | 1 x 8 Ohm |
| Inputs | 1 x 1/4" |
| Outputs | 1/4" Line Out |
| Power Supply | 24V DC |
Covers general safety warnings, electrical precautions, and environmental considerations for safe operation.
Essential steps before powering on, including reading instructions and checking voltage.
Adjusts input sensitivity and saturation level of the preamplifier for distortion.
Controls power amp saturation behavior and volume impact at different levels.
Footswitch to disconnect preamp or control FX Loop, depending on mode switch.
Adjusts the overall volume of the StompMan, affecting both channels.
To Next Page
