Parts Included
Installation Guidelines
This product is intended to be used with Humanscale’s Monitor Arm product
line and the following oce desk styles placed on a non-skid surface:
1. Systems Furniture with panel hung surfaces
2. Systems Furniture with a floor mounted panel behind the desk
3. Systems Furniture with a desk mounted panel in the rear of the desk
4. Back-to-back desks sharing the same frame
When mounting monitor arm and monitor(s) with this product on a
freestanding desk/table:
1. The freestanding desk/table should have a base that is no less than 30” deep and 66.5” wide
2. The freestanding desk/table should be a minimum of 200 lbs and placed on a non-skid surface.
3. The tabletop thickness should be no less than 1.2 inches and strong enough to support a minimum weight
load of 165lb.
CAUTION: DO NOT ROTATE MONITOR PAST REAR EDGE OF DESK. DOING SO CAN
CREATE AN UNSTABLE SITUATION AND MAY CAUSE EQUIPMENT DAMAGE OR
PERSONAL INJURY.
3
M/Connect Hub and Dock
USB-C Upstream Cable
Bridge Cable A
Power Adapter
①
④
②
③
To Next Page
Loading...
