Humanscale QuickStand Eco - Base and Post Assembly

3
Step 2
Slide the main post onto the base by inserting the 2 tabs in the front and
secure the main post with 6 screws. Snap on the plastic covers removed in
step1. Rear cover rst then front cover.
Step 1
Place the base on a desk and remove the plastic covers and set them aside.
X 6
STEP 2
• Slide the main post onto the base by inserting the 2 tabs in the front
and secure the main post with 6 screws using the 4 mm hex key.
• Snap on the plastic covers removed in Step 1, placing the
rear cover first, then the front cover.
STEP 1
• Place the base on a desk and remove
the plastic covers and set them aside.
Step 2
Slide the main post onto the base by inserting the 2 tabs in the front and se-
cure the main post with screws. Snap on the plastic covers removed in step1.
Rear cover rst then front cover.
Step 1
Place the base on a desk and remove the plastic covers and set them aside.
Step 2
Slide the main post onto the base by inserting the 2 tabs in the front and
secure the main post with 6 screws. Snap on the plastic covers removed in
step1. Rear cover rst then front cover.
Step 1
Place the base on a desk and remove the plastic covers and set them aside.
X 6