Humanware BrailleNote Touch Plus - Safety and Maintenance

123
the same orientation as the document. Then, lift your Touch straight up to an appropriate distance;
about 3 to 5 inches away from the document.
To take a picture, with your focus on the “Take Picture” button, simply press a cursor routing key.
Alternatively you can press the Touch’s Action button, located on the right side of the device. You will
hear a camera shutter sound. For best results, avoid moving the BrailleNote Touch while the picture is
taken.
When the text is recognized, it should appear in Braille on the display. Navigate with your left and right
thumb keys or press SPACE with DOT 1 or dot 4 to move line by line through the recognized content.
You can save the document by navigating to and activating the Save Document button, or use first letter
navigation by pressing S.
To access the full KNFB Reader user guide, select File Explorer and press ENTER or a cursor routing key.
Select Full user guide and press ENTER or a cursor routing key to read it. To exit the user guide, simply
press Back.
Appendix F – Safety and Maintenance
General Care
Keep beverages away from your BrailleNote Touch. Periodically wipe the case down with a warm damp
cloth. Don’t use any cleaning compounds.
Braille Display Care
Each cell of the Braille display has eight pins. For each pin there is a special crystal that lifts the pin to
make a dot, and allows the pin to drop when there is no dot. The pins have to be able to move freely. In
normal use dirt unavoidably accumulates on the display and around the Touch cursor routing keys. To
prevent the pins from jamming, the display and touch cursor should be cleaned regularly. Cleaning the
Braille display is not straightforward. We recommend that you send the BrailleNote BT back to an
authorized BrailleNote BT service center every twelve months to clean the Braille display.
Making sure that your hands are always clean is a good start towards minimizing problems with your
Braille display. We suggest that once per week you wipe the surface of the Braille display using a soft
damp cloth. The cloth should be squeezed hard to ensure that all excess moisture has been removed.
Use only warm water on the cloth.
FCC / Industry Canada Two Part Statement:
This device complies with FCC Part 15 and Industry Canada license exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.