Inspection, care and maintenance
287
Electrical system
1
2
3
4
5
6
7
8
“LED” tail light
Fig. 62 Tail lighting “LED” 24 V
1 Outer lens
2 Rear fog light
3 Reversing light
4 Tail light with reflectors
5 Brake light
6 Indicator
7 Extension with peripheral light
The LED light bodies must be replaced
completely if defective.
Replace the tail lights with the
manufacturer's original replacement
parts only.
The type is marked on the lights.
Fig. 63 Tail lighting “LED” 12 V
1 Inner light body
2 Reversing light
3 Rear fog light
4 Connection cable
5 Outer light body
6 Tail light with reflector
7 Brake light and indicator
8 Extension with peripheral light
The LED light bodies must be replaced
completely if defective.
Replace the tail lights with the
manufacturer's original replacement
parts only.
The type is marked on the lights.
Fig. 64 Tail lighting, mounting
1 Screw connection, inner light body
2 Connection cable
3 Screw connection, outer light body
4 Screw connection, extension
Disconnect the corresponding screw
connection (Fig. 64/1, 3, 4).
Disconnect the corresponding
connection cable (Fig. 64/2).
Insert the new LED light body.
Connect the connection cable.
Tighten down the screw connection.
Check the function of the LED lighting.
W - 063
1
2
3
5
6
7
4
W - 065
1
2
3
5
6
7
4
8
W - 066
3
1
4
2
To Next Page
