1-5
Easy Exit Seat
This feature makes entering or leaving the driver’s seat
easier.
(Exit): This button is used to program and recall
the desired driver’s seat exit/entry position. The seat
position can be personalized for driver 1 and driver 2.
To store the seat exit position for driver 1 or driver 2,
do the following:
1. Select the desired driver number by pressing the
1 or 2 button. The seat will move to the last stored
memory position.
2. Adjust the seat to the desired exit/entry position.
3. Press and hold the the exit button for three seconds.
A double chime will sound to let you know the exit
position has been stored for the identified driver
(driver 1 or 2).
To use the exit/entry feature, do one of the following:
D
Press the exit button on the memory control.
D
Or, if you have this feature enabled (active) in the
DIC, then removing the key from the ignition will
cause the seat to move to the exit/entry position.
See “Driver Information Center” in the Index.
Heated Front Seats (If Equipped)
The buttons for the driver’s
side heated seat are located
on the driver’s side door
panel. The buttons for the
passenger’s side heated
seat are located on the
passenger’s side door panel.
The engine must be running for this feature to operate.
To heat the entire seat, press the horizontal button with
the heated seat symbol. Press the button to cycle through
the temperature settings of high, medium and low and
to turn the seat off. The indicator lights will glow to
indicate the level of heat selected: three for high, two for
medium and one for low.
The low setting warms the seatback and seat cushion
until the seat temperature is near body temperature.
The medium and high heat the seatback and seat cushion
to a slightly higher temperature. You will be able to feel
heat in about two minutes.
To Next Page
Loading...
Need help?
General
