44
7. SET UP THE LIGHTNING FUNCTIONS
7
NOTE THE HIGH SPEED GAIN BLADE EXTENTION percentage number, to
input into the LCP later in Section 7.3.2.
1
7.3.2 INPUT COORINATED TURN DATA INTO THE CONTROL PANEL
INPUT THE RUDDER DEADBAND percentage values into the RUDDER
DEADBAND screen of the LCP:
COORDINATED TURN > RUDDER DEADBAND
• Use the + and - buttons to input the correct value.
2
INPUT THE LOW SPEED GAIN blade extention percentage into the LCP:
COORDINATED TURN > LOW SPEED GAIN
• Use the + and - buttons to input the correct value.
To Next Page
Loading...
