hune 6000RL-M - System Initialization and Operations; Initialization; Add User Operation; Delete User Operation

 Modify password：
【#】+〖user code〗+〖password〗+【#】+〖user code〗+〖new user password〗
+【#】
Remarks: two times user code must be same.
 Unlock the door：
〖user code〗+〖password〗+【#】
4. Initialization
a. Press【#】+【0】+【3】+【#】
b. Hear beep, press deadbolt button last for 3seconds.
c. After one beep, release deadbolt button.
d. Yellow light flash, after delete lock information successfully will have one
long beep.
e. After initialization, delete all information. System have default master, ID
code is“0”, and initial password “11111111”
OPERATION INSTRUCTION
1. Add user（0X10）
【#】+〖master code〗+〖master password〗+【#】+〖“10”〗+【#】+〖new user
code〗+〖new user password〗+【#】+〖user level〗+【#】
Remarks:
a. “user level”is optional, if use default can pass it then press
“#”.
b. Default user level, “ 03-ordinary user ”， 02—general user
03—ordinary user 04—temporary user 05—user defined
2. Delete user（0X20）
【#】+〖master code〗+〖master password〗+【#】+〖“20”〗+【#】+〖user
code be deleted〗+【#】
3. Modify password（0X30）
【#】+〖user code be modify password〗+〖old password〗+【#】+〖“30”〗
+【#】+〖new password〗+【#】+〖new password again〗+【#】
a. Two times new password must be same.
b. When first press new password can press“#” double times then modify
the password directly.
4. Modify user level（0X31）
【#】+〖master code〗+〖master password〗+【#】+〖“31”〗+【#】+〖user
code be modified〗+【#】+〖user level〗+【#】