EasyManuals Logo

Hunter 2000 User Manual

Hunter 2000
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6.!Operation!of!double!sound!(Run!and!Point)!
6.1 The Beeper contains an internal magnetic switch that controls:
Activation/ Function Run and Point, and Deactivation
This switch is located on the inside of the Beeper at the point where the label is.
A) Activation / Function Run and Point:
To activate the Beeper swipe the magnet over the magnetic switch. The Beeper
immediately emits a sequence of four beeping sounds. This sequence indicates also
the function Run and Point.
B) Function Point Only:
After activating the Beeper by following the previous step, turn the right scroll-
wheel counter-clockwise. By turning the right scroll-wheel, counter-clockwise, the
RUN sound is repeated every 10, 20, 30 seconds, infinite (Point Only Function).
C) Deactivation:
To deactivate the Beeper swipe the magnet over the magnetic switch. You will hear a
sequence of three beeping sounds repeated twice (beep, beep, beep - beep, beep, beep
= off).
7.!Adjustment!of!Run!and!Point!sounds!
7.1 Adjusting the time of sound Run:
When using the function Run and Point, the sound Run is repeated by an interval,
which is adjustable by the scroll-wheel of the seconds (right). It is possible to adjust
the range from 10, 20, 30 seconds to infinite seconds (Point Only Function). Scrolling
clockwise the interval becomes shorter (minimum 10 seconds). Scrolling counter-
clockwise, the interval becomes longer (maximum is infinite).
The duration of the battery’s life depends on the adjustment of the intervals (more
sounds = shorter battery life). Please note: the beginning of the Point sound is 3-4
secs after your dog stops moving. The Point sound is fixed at an interval of two
seconds and it is not adjustable.
7.2 Selection of Run and Point sounds:
The Beeper has four different sounds for both Run and Point sounds (total of sixteen
possible combinations). You can adjust the sounds by four different switches.
Switches 1 and 2 regulate the Point sounds. Switches 3 and 4 regulate the Run
sounds. It is therefore possible to choose the same sound for Run and Point or you
can choose from sixteen other combinations.
7.3 The four different sounds are:
1. Double beep
2. Trill-tone
3. Two-tone
4. Hawk-scream

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hunter 2000 and is the answer not in the manual?

Hunter 2000 Specifications

General IconGeneral
BrandHunter
Model2000
CategoryPet Care Product
LanguageEnglish

Related product manuals