14
42616-01 • 02/02/10 • Hunter Fan Company
8-6. To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only t together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.
8-7. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower switch
housings. Attach the lower switch housing to the upper switch
housing
8-8. To install each shade, rst loosen the three thumbscrews.
8-9. Raise the shade to the light xture. Tighten the thumbscrews
securely.
8-10. Install candelabra-based light bulbs (40 Watt maximum each).
Note: Glass shade style and number of lights may vary.
Lower
Switch
Housing
Plug
Connector
Steps 8-6 – 8-7
Plug
Connector
Detail
Upper
Switch
Housing
Steps 8-8 – 8-10
umbscrews
Shade
Bulb
Housing
Assembly Screw
8 • Completing Your Installation With or Without a Light Fixture (Cont.)
Note: In compliance with U.S. Federal energy regulations, this
ceiling fan contains a wattage saver that restricts the light
kit to a maximum of 190 Watts. Exceeding that limit or the
specications on the light socket may result in re hazard or
improper operation. If lights do not appear to be operating
properly, see the troubleshooting section.
To Next Page
Loading...
