Hunter 20345 - Uninstalling the Light Fixture

15
42616-01 • 02/02/10 • Hunter Fan Company
8 • Completing Your Installation With or Without a Light Fixture (Continued)
Uninstalling the Light Fixture
8-11. To uninstall the light xture, rst disconnect the plug
connectors between the black wire and the red wire.
8-12. Disconnect the plug connectors between the two white
wires.
8-13. Uninstall the nut and washer from the end of the light xture
inside the lower switch housing.
8-14. Unscrew the threaded rod of the light xture from the lower
switch housing.
8-15. Remove the light xture screws, then remove the light xture.
8-16. Remove the light xture from the lower switch housing
pulling disconnected wires through the hole in the center of
the lower switch housing.
Note: When removing the wires, pull the thin plug connector
(male) through rst, and then pull the other plug connector
(female) through the hole.
8-17. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
8-18. Install the switch housing cap and plug button to the lower
switch housing.
Step 8-18
Cap
Plug Button
Male Dummy
Terminal
Female Dummy
Terminal
Light Fixture
Screws
Step 8-15