Hunter 30420 - Using Your Air Purifier; Initial Setup and Operation

44111-01 • 02/27/2012
4
1. Take the air purifier out of the box and place the unit
on a firm, level surface.
2. Before turning on the air purier, conrm that the lter is
rmly in place and has not become loose during shipping.
To release the door, press the oval buttons on each side of
the unit. Figure 1.
3. Gently pull the grill away from the unit and lift away.
Figure 2.
4. The HEPAtech
®
lter will be resting inside the unit. Ensure
the lter is fully seated in the unit by pressing all four
corners of the lter. Figure 3.
5. When the lter is in the correct position, the arrow printed
on the side will point toward the back of the unit. Figure 4.
6. To replace the grill, set the tabs on the each side of the
bottom of the grill into the notches in the base of the unit
(Figure 5) and rock the grill up until the top of the grill is
secured by the oval buttons into the oval holes. Push until
the grill “clicks” into place. Figure 1.
7. Plug the unit into a 120V electrical outlet.
Figure 5
Figure 3
Press Here
Using Your Air Purifier
Your air purier was thoroughly inspected and tested at the
factory prior to packaging. Visually inspect it upon removal
from its box. Remove and discard any packaging material.
Return the unit if it shows any signs of damage or mishandling.
OPERATION:
INITIAL SETUP:
Each time you start the air purier, it is a good idea to run it
on high for a few seconds for fast, initial cleaning. Then set to
medium or low as desired.
CAUTION! NEVER operate the air purier
without the HEPAtech lter properly installed.
Permanent motor damage could occur.
Figure 4
Figure 1
Oval
Button
Figure 2
Filter
Notches
Tabs