44111-01 • 02/27/2012
6
Figure 6
The usable life of a HEPAtech lter is approximately 4 months
depending on the level of contaminants in the room and the
frequency of use. The HEPAtech lter will turn medium brown
and air volume will begin to decrease dramatically when the
lter needs to be changed. You should have a spare lter
available for later replacement.
The HEPAtech lter is specically designed for easy
replacement to provide maximum performance.
THE FILTERS ARE NOT WASHABLE.
1. When the pre-lter or lter light is illuminated, you should
open the front grill and replace the lter.
2. When you change the lter, press the reset icon .
Figure 6.
3. Turn the air purier OFF and unplug it from the power outlet.
4. Press the oval buttons on each side of the unit to release
the grill. While, lifting up and away from the unit, remove
the grill. Figure 7.
5. Remove and discard the lter.
6. Remove any plastic or protective wrapping and/or
packaging from the new lter.
7. Set new lter into the air purier. Ensure the lter is seated
fully into the unit by pressing all four corners of the lter.
Figure 8.
8. Install the front grill by engaging its tabs into the bottom
slots on the unit. Figure 9. Then swing grill up and gently
push in top to snap into place. Figure 10.
9. Plug the air purier into an outlet for operation.
Figure 10
REPLACING THE FILTER:
Figure 7
Oval
Button
Maintenance (continued)
Figure 8
Press Here
Figure 9
Notches
Tabs
To Next Page
Loading...
