Hunter 30943 - Changing the QuietFlo Main Filter

11 42937-01
Air Purier Maintenance
6. Place the Front Grill back onto the unit.
7. Plug in the Air Purier.
8. To reset the Pre-Filters & Carbon Odor Filter Life Counter to zero, press
and hold the Pre-Filters & Carbon Odor Filter Reset Key for three sec-
onds. When the display shows 100%,, release the Key. The Counter is
now reset.
Changing the QuietFlo
®
Main Filter
When the QuietFlo
®
Main Filter Life Counter reaches 0% (approximately 10 to 12
months of use), you should replace the lter. Refer to Filter Life Counters for ad-
ditional information, pg. 9. The proper time to change the lter depends on usage
and the environment. Generally, if you notice a decrease in air output or an increase
in noise at any time during normal operation, the lter may be clogged. Replace the
lter to return to normal operation.
To change the lter and reset the Filter Life Counter:
1. First, turn off and unplug the Air Purier.
2. Next, remove the Front Grill. Place your ngers under the Grill Release
Handle and pull up. Refer to Figs. 4 and 5 (pg. 6).
3. Lift the Filter Tab and gently pull the lter out of the unit. Refer to Fig. 6.
While removing the lter, note the lter’s orientation - the new lter will
be installed with the same orientation. Refer to Fig. 10. Once removed,
the used lter can be discarded.
4. To install a new lter, position the lter with its rim facing the unit. Refer
to Fig. 10.
FILTER RIM
FILTER FRAME
Fig. 10