44067-01 • 10/13/2010
32
6
Features
Additional Features
There is no need to stand at the wall where the thermostat is mounted while
programming or changing settings. Simply remove the thermostat from the
wall and make the necessary changes in the comfort of a chair. You can also
set your programming and settings before you even install the thermostat.
Armchair Programming
In the event that power is lost, the batteries will act as backup, saving your
settings and programs.
Power Failure Protection
To protect your system from cycling, system turning on and off rapidly, your
thermostat will prevent your system from turning back on for up to 3 minutes
after it has been shut down.
System Protection
In situations where your thermostat may not seem to be operating properly
or if you just want to reset and start over, press and hold the
and
buttons for 5 seconds until the screen ashes “Updated!”. This will restore the
thermostat to factory condition.
Reset
To Next Page
Loading...
