Hunter 52594 - Canopy Installation; Securing the Canopy Cover; Blade Installation; Attaching Blade Arms to Motor

7
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Glass Remote
Installing the Blades:
Repeat x5
x10
bag
Blade Arm Screw
Align the three blade holes with the three blade iron posts. Squeeze
the blade and the blade iron post together.
The ared tops of the blade iron posts will be fully visible above the blade when
properly assembled.
Installing the Canopy
x2
Lift the canopy into place so that
the screw holes are aligned.
Insert the two canopy screws
found in the
hardware bag.
F
i
t
t
h
e
c
a
n
o
p
y
i
n
p
l
a
c
e
a
s
s
h
o
w
n
.
bag
Canopy
Screw
Installing the Bulbs and Glass
Assembling the Light Kit
Lightly attach the blade arms to the
motor with screws found in the
hardware bag, then securely tighten
after both screws are attached.
Repeat x5
IMPORTANT
NOTE: The blade arms should be mounted with
the ridge facing downward. Installing it incorrectly
could result in your fan not functioning.
Ridge