Hunter ACC2 - Pump;Master Valve Setup

14
ACC2 STRONGBOX PEDESTAL ASSEMBLY INSTRUCTIONS
Assembly
Reassembling the Hunter ACC2 inner
chassis assembly: Power supply assembly
(Decoder version shown)
Step 1: Reconnect the two cables from the
deck assembly (Fig. 1).
Step 2: Reconnect the cable from the
junction box assembly (Fig. 2).
Step 3: Reinstall the power supply assembly
being careful not to pinch any of the cables.
Power supply assembly should sit ush.
Tighten the captive screws (qty: 3) using #2
Phillips head screwdriver (Fig. 3).
Fig. 1 Fig. 2 Fig. 3
○
○
○
○
○