1.5 SD Card Selection
Using a memory card is required to operate the camera. When the camera is "ON"
and no memory card is used, the screen displays "Please insert memory card". The
SD slot of the camera has a 32 GB memory capacity. Before inserting or removing
the memory card, the camera must be turned "OFF". Failing to do so may cause loss
of or damage the pictures already recorded from the memory card. When the SD
card is full, the viewing screen indicates "Memory Full". The following data shows an
approximate quantity of photos which can be recorded by the camera depending on
the memory card capacity.
Chart below will show you the approximate capacity of different size SD cards.
Please check to see which size card can fit your needs best.
1.6 USB Connection
When camera is connected via USB cable; screen display “MSDC”, press “Menu”
once, “MSDC” turns to “PC Cam”, camera now can be used as a PC camera; press
“Menu” again, camera exits PC camera mode.
1.7 Attention
1. Insert the SD memory card correctly, camera does not support SD card hot swap
(insertion).
2. Please use high-quality AA batteries in order to prevent battery cells from
corrosion of leaked acid.
3. Use right adaptor (12V/1~2A) of this camera to supply power, and do not invert the
electrode when put in batteries.
4. In Test mode, camera will automatically turn off if no keypad touching within 5
minutes. If you want to let camera enter PIR Auto Mode again, please manually
switch the button to “ON”.
5. In the condition of light screen, no matter in the main interface or menu interface,
without any keypad operations within 5 minutes, camera will turn off automatically.
6. Don’t interrupt power supply during system upgrade, please deliver it back to
factory if the device doesn’t work after upgrading.
7. Do not frequently insert or pull out SD card and battery or plug in and out the
adapter when the camera is on.
To Next Page
Loading...
