Hunter Energy Monitor AC 42205 - Troubleshooting; Resetting the Filter Counter; Common Display and Operation Issues

Information/ f
Troubleshooting
To Reset the Filter Counter to Zero
Continue pressing
■
FILTER
C * «u
I
uc
< J
■ Indicates the usage of lilter in nours
and minutes.
*
m
FILTER
n-nn
u • u u
♦ t»tf p
nn
u u
M The counter is reset to zero.
■ - -
: „
u
o • r C
Ji • 1
-lO
IU
i p To return to current time ano temp.
NOTH: When filter usage counter is reset, it w»H res
are not affected. However, when usage counter
to sera
;ei omy ine imw — * * \
is reset all usages including lilter counter are reset
Problem S° > u t i o n
■ —— ■ fc— — — — ■■ ^
No Display
1. Check battery. .
2 . Press reset button once with a smalt pin ana
hold in tor two seconds
entire Display Dims or Rashes
Rapidly On and Off
1, Replace battery.
Program Does Not Change at
Your Desired Setting
1 . Check that time is set properly to **AM”
or “RMT
Z Check that thermostat is not in “HOLD mode.
3. Check for correct day setting.
Cooling Does Not Go On or Of!
1. Check that lunctiop.switch is in correct
position. - ^ , .
Z There may be as much as 10 seconds delay in
the thermostat turning the system on—wait
and check.
3. Check your circuit breakers and switches to
ensure that there is power to me system.
4. Replace battery.
5. A built-in timer prevents damage to your air
conditioner compressor caused Dy rapid
cycling by providing a four minute delay before
restarting the compressor,
&ratic Display
1 . Press the reset button once with a smalt pm
and hold in lor two seconds. Then reprogram.
Note: For proper operation always set the temperature control ol the room air conditioner unit to max-
imum cool position.
It you experience any other prosiems. call 901-745-9222 from a a.m. to 5 pm. Central lime.