The remote control should be charged for 4-5 hours. Connect the charger to the remote control USB
connector on the top.
PAIRING AND USE THE GPS-TRAINING COLLAR
The collar you purchased is already paired with the remote control. If you want to pair it again, follow the
instructions below. The remote control can control up to 9 collars. The remote control has a + and a - button
for collar selection to send commands.
PAIRING: Switch on the remote control from the ON / OFF button, then switch on the collar. When the
collar is switched on the red indicator led of the collar flashes. Press for 4-5 seconds the screen light button
and the speaker icon on the screen will start flashing. The remote control is in tuning mode. Now hold for 10
seconds the back of the remote control (where the built-in magnet is) at the point where the collar indicator
led is located. After 10 seconds remove the remote control from the collar and if you hear 3 consecutive beep
sounds from the collar, press the shock command button for 2 seconds. You will hear a beep sound,
indicating that the sync was successful.
Repeat the same procedure if you want to sync other collars.
When you finish adjusting the collars, press the audio command button to return the remote control to
normal operation.
When you press the remote control shock button, a shock command is sent to the corresponding collar. Each
time you press the audio command or the push button or the audio + shock button, the screen flashes,
indicating that the command is being sent to the collar. The level of shock fluctuates using the number
buttons on the remote control from 1 to 8. Level 1 is the lowest and level 8 is the highest.
After use, you can switch off the remote control using the ON / OFF switch.
TIPS FOR USING THE GPS-TRAINING COLLAR
The device is specially designed for hunting dogs and works under harsh conditions (rain, dense vegetation
etc). It is lightweight, durable and is ideal for both small and large size dogs.
The collar should be positioned on the bottom of the dog's neck (facing the ground). The two probes should
touch the dog's skin so it can feel the stimulus. Place it tight on the neck and if the dog has long fur, trim it
slightly so that the probes make contact with the skin.
You need to find the right power level for your dog. Start from level 1 and if you see no reaction use level 2.
Increase the level until you see a reaction from the dog. When the dog reacts you have found the level you
need to use. If you use level 8 which is the highest and you see no reaction from the dog then the collar has
not been properly placed on its neck. It should be tight and if the dog has long fur, trim it so the probes make
contact with the skin. Use short or long probes depending on the dog's fur.
Always be present during the charging process of the devices. It is recommended to charge once per month
during the period you do not use the device and store it always charged in a dry place with temperatures
below 40 degrees. We advise to charge the collar and the remote control prior to each use.
To Next Page
Loading...
