Hunter Gravity - Canopy and Blade Installation; Installing the Canopy; Installing the Blades

7
1886
1886
Installing the Glass
Assembling the Light Kit
Installing the Canopy
x2
Lift the canopy into place so that
the screw holes are aligned.
Insert the two canopy screws
found in the
hardware bag.
F
i
t
t
h
e
c
a
n
o
p
y
i
n
p
l
a
c
e
a
s
s
h
o
w
n
.
bag
Canopy
Screw
Installing the Blades:
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass Remote
x18
bag
Blade Screw
x18
bag
Blade Nut
Repeat x6
Secure each blade to a blade iron as shown using the blade nuts, found in the
hardware bag, and the blade assembly screws, found in the hardware bag.
Fan style may vary.
Note:
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Repeat x6
x12
bag
Blade Arm Screw
Lightly attach the blade arms to the motor with
screws found in the hardware bag, then
securely tighten after both screws are attached.
Fan style may vary.
Note:
IMPORTANT
NOTE: The blade arms should be mounted with
the ridge facing downward. Installing it incorrectly
could result in your fan not functioning.
Ridge