Hunter Hartland - Installing the Blades; Blade Attachment; Blade Arm Installation

5
6
1886
1886
Ceiling Bracket Hanging Fan Hanging Fan (Cont.)Wiring Blades Light Glass/Bulbs Pull Chain
Hanging the Fan (Continued)
2 of 3
Canopy
Screws
bag
3 of 3
Canopy
Screws
bag
Swing the fan up to align the
canopy screw holes with the
mounting holes on the ceiling plate.
Hold the canopy up with the screw holes
aligned. Partially install two canopy screws,
found in the hardware bag, into the
holes opposite the ceiling plate hooks.
Partially install a canopy screw, found
in the hardware bag, between
the ceiling plate hooks. When all the
holes are properly aligned, securely
tighten all three canopy screws.
Note: The slots in the canopy must
remain engaged while swinging the
canopy for alignment.
Fan style may vary.
Note: