4
Mounting The Expansion Module
1. Using a drill bit of ⁄ inch diameter, drill
a hole to a depth of 1 inch (25 mm).
2. Insert plastic anchor so it is ush with
the surface of the wall.
3. Screw 1 inch screw into anchor leaving
the head protruding about ⁄ inch
(4 mm).
4. Slide the controller case over the
screw head.
5. Mark second mounting point (see in
diagram), remove expansion module,
drill hole, insert plastic anchor, slide
controller case over rst screw head
and screw into place.
Rear cable entry point
(remove with knife)
Conduit cable entry point
(remove with knife)
Wall mounting screw
Power indicator
Expansion module
cable entry
Go to previous screen
Go to home screen
To Next Page
Loading...