8
TROUBLESHOOTING
My Expansion Module ID Color Is An Orange Color
• Check that you have added an expansion module for your controller in the Hydrawise
App (see section Hydrawise App Conguration above for instructions).
• Check that the congured Expansion Module ID on your Expansion Module matches
your Hydrawise controller conguration.
• Check that the master controller is connected to wireless.
All Expansion Module ID Colors Are A Grey Color
• You have not congured an Expansion Module ID on the Expansion Module. Touch
either button 1 or 2 on the Expansion Module to set the Expansion Module ID.
Expansion Module Zone Not Starting
• Check that the Expansion Module ID on the Expansion Module is a Green color and the
status is Online.
• If your old controller had a master valve (sometimes referred to as MV) then you must
congure a master valve in the app and wire this to a spare zone on the controller.
Detailed instructions can be found on the Hydrawise website.
• Check that your wiring is correct. If no solenoids start then check that your COMMON
wire is correctly wired.
hunter.direct/hchelp
Find more helpful information on your product? Find tips on installation, controller programming and more...
LIT-694-QS-EM US 10/16
To Previous Page
Loading...