Hunter Hydrawise HC-1200M - Installation; Cable Entry

3
INSTALLATION
Expansion Module Location
The Hydrawise Expansion Module is designed for installation in a protected location.
The chosen location for the expansion module should be within 20in (500mm) of the
main controller.
Cable Entry
The Expansion Module has 2 cable entry options – from the rear of the case or via a conduit
from the bottom of the Expansion Module.
1. Entry from rear of module- Using a sharp knife, remove the 2 cutouts on the rear of the
expansion module as indicated on the diagram as .
2. Entry via ¾ inch conduit- Using a sharp knife, cut around the semi-circular line on the
expansion module as indicated on diagram as . Cut around the matching line on the
blue controller wiring cover.