Hunter Key Biscayne - Downrod Assembly Details; Preparing Downrod for Insertion; Tightening Downrod Setscrew; Wire Preparation for Downrod

www.HunterFan.com
1.888.830.1326
8
M3556-01 • 06/17/14 • © Hunter Fan Company
KEEP!
8”
3/8”
C
U
T
&
S
T
R
I
P
(not to scale)
Remove the pre-installed
setscrew so that the downrod
can be inserted.
Hand tighten the downrod (at
least 4-5 full turns) until it stops.
The wires can be cut, but
leave at least 8” extending
from the top of the downrod.
Downrod (continued)
8”
3/8”
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
If the setscrew is not tightened
securely, the fan may fall.
K
E
E
P
!